Belt cable tie 6 to 9mm wide, 175 to 750mm long

When wiring an industrial control cabinet, cablers use these collars to pre-align the wires before connecting them to the terminals. Once all in place, the mounting collars are removed or replaced by permanent fasteners. This technique allows you to work cleanly, save time and limit path errors.

According to feedback from manufacturers, this type of necklace is virtually absent from foreign markets. In Germany, Italy or the United States, direct use is preferred. Traditional clamps. The French specificity is explained by a culture of beam organization, inherited from electrical and telecom cabling practices, and the lobbying of industrial Legrand. This explains why manufacturers continue to offer ranges dedicated only to this market.

The installation collar is distinguished by :

• its rapid implementation. Use of a clamping and cutting collars are highly recommended.
• the possibility of reorganising a beam at will,
• no marking or crushing on cables. The teeth are outside the collar, so do not come into contact with the beam as for a cable tie classic. Teeth inside the collar interfere with the organization of the cables, and may even hurt them.
• a valuable help to keep an installation legible and orderly.

These necklaces complete the classic fastening and protection solutions. They are to be considered as a temporary or semi-permanent work tool, allowing to prepare a wiring before final installation. Their use remains largely concentrated in France, but they represent real know-how in how to approach wiring : organization, accuracy and method.