Pliers to tighten installation collars

Détails :

This clip allows you to easily tighten all your cable clamps and installation collars, and to cut off the length that has become useless from the necklace.

One advantage of this clamp is that clamping and cutting are dissociated. Thus, you decide to cut the length when you feel that the clamp is satisfactory.

There is no clamping force limiter, visually control and trying to move the collar and beam that you have not too tight. If you're too tight, you could hurt the beam. Indeed, the effort you apply to the lever is multiplied at the level of the clamp tension, so as soon as you have a resistance on the lever, be careful to tighten moderately and control the clamping on the support.

Once the collar is tightened, the tongue lengther is easily scratched with a second small lever. A little pressure on the lever, and the tab is cut. Be careful, once the length is cut, you can no longer tighten the collar.

With its permissible width of up to 9 mm, this clamp is suitable for clamping and cutting the installation collars. Only one clamp covers more than 99% of the cases of clamping and cutting of length, since this clamp can tighten and cut from a width of 2.5 mm to 9 mm.

This clamp to tighten and cut responds to a large majority of cases of use, moreover, it is you who decide when you need to cut the length. It is important to specify this because some clamp models automatically trigger the cut from a certain tension value of the collar, and you cannot adjust the latter value.